RM新时代官方-首页

　　Automatic mixer in the operation, if suddenly there is a lot of noise, it means that there is a problem in one of the places, and the noise problem is also a problem that many people are very disgusted with.. Only by properly dealing with the noise problem can the noise be reduced. What is the cause of the noise? How to solve it?

　　一、原因

　　1、 Why

　　1、自動攪拌車濾芯堵塞也是會造成噪音大。

　　1. Automatic mixer filter plug will also cause noise.

　　2、工作的油液不合要求或油液粘度太大。

　　2. The working fluid does not meet the requirements or the oil viscosity is too high.

　　3、車油箱液面太低，油面上空氣被吸入泵內。

　　3. The fuel tank level is too low, the air on the oil level is sucked into the pump.
         

　　4、吸油管路進氣或堵塞。

　　4. Air intake or blockage of oil suction pipe.

　　5、泵的安裝支架的剛性不足，工作時會產生震動和噪音。

　　5. The rigidity of the pump's mounting bracket is insufficient, which will cause vibration and noise when working.

　　6、混凝土攪拌車罐體內有粘結的混凝土存料行駛中會產生噪音。

　　6. There is bonded concrete in the tank of concrete mixer truck, and noise will be generated during driving.

　　二、

　　2、 Solve

　　1、清洗或更換濾芯。

　　1. Clean or replace the filter element.

　　2、更換低粘度的液壓油。

　　2. Replace the low viscosity hydraulic oil.

　　3、給自動攪拌車補加相同標號的液壓油。

　　3. Add the same grade of hydraulic oil to the automatic mixer.

　　4、檢查擰緊，不要吸進空氣。

　　4. Check tightening, do not breathe in air.

　　5、加固支架。

　　5. Reinforce the bracket.

　　6、要清鏟干凈。

　　6. Clean the shovel.

　　我們應該仔細檢查一下內部的配件，觀察哪里出現了問題。并且需要及時補充潤滑油，防止出現磨損的情況。在駕駛的時候一定要做到平穩運行。另外加固配件，防止松動。

　　We should check the internal fittings carefully to see what's wrong. In addition, the lubricating oil needs to be replenished in time to prevent wear. Be sure to run smoothly when driving. In addition, reinforce accessories to prevent loosening.