RM新时代官方-首页

如果自動上料攪拌車車輛在行駛中發生剎車失靈，應該怎么辦呢？下面來講講原因以及怎么問題的內容。

What should we do if the brake of the automatic feeding mixer truck fails during driving? Now let's talk about the reason and how to solve the problem.

造成自動上料攪拌車剎車失靈的原因：

Causes of brake failure of automatic feeding mixer:

一是對剎車系統缺乏必要的保養，剎車總泵里雜質太多、密封不嚴、真空助力泵失效、剎車油過臟或幾種剎車油混合使用受熱后出現氣阻、剎車總泵或分泵漏油、儲氣罐或管路接口漏氣；二是由于操作不當導致機件失靈，如長時間下坡會使剎車片摩擦生熱、剎車轂炭化、剎車功能完全失效；三是由于嚴重超載，在重力加速度的作用下，加大了車輛運動慣性，直接導致剎車失靈。

First, there is a lack of necessary maintenance for the brake system. There are too many impurities in the brake master cylinder, the sealing is not tight, the vacuum booster pump fails, the brake oil is too dirty, or several brake oils are used together and heated, and air resistance occurs, the brake master cylinder or slave cylinder leaks, and the air reservoir or pipeline interface leaks; Second, improper operation leads to failure of parts. For example, long downhill will lead to friction heating of brake pads, carbonization of brake hubs, and complete failure of brake functions; Third, due to severe overloading, under the effect of gravity acceleration, the vehicle motion inertia is increased, which directly leads to brake failure.

自動上料攪拌車剎車失靈怎么辦

How to deal with brake failure of automatic feeding mixer

1、根據路況和車速控制好方向，脫開高速擋，同時迅速轟一腳空油，將高速擋換入低速擋。這樣，發動機會有很大的牽引阻力使車速迅速降低。另外，在換低速擋的同時，應結合使用手剎，但要注意手剎不能拉緊不放，也不能拉得太慢。如果拉得太緊，容易使制動盤“抱死”，很可能損壞傳動機件而喪失制動能力；如果拉得太慢，會使制動盤磨損燒蝕而失去制動作用。

1. Control the direction according to the road conditions and speed, disengage the high gear, and quickly blow a foot of empty oil to shift the high gear to the low gear. In this way, the engine will have great traction resistance to reduce the vehicle speed rapidly. In addition, the handbrake should be used in combination with the lower gear, but it should be noted that the handbrake cannot be tightened or pulled too slowly. If the brake disc is pulled too tight, it is easy to "lock up" the brake disc, and it is likely to damage the transmission parts and lose the braking ability; If the brake is pulled too slowly, the brake disc will be worn and ablated, thus losing the braking effect.

2、利用車的保險杠、車廂等剛性部位與路邊的天然障礙物摩擦、碰撞，達到強行停車脫險的目的，盡可能地減少事故損失。

2. Friction and collision between rigid parts such as bumpers and carriages and natural obstacles on the roadside are used to achieve the purpose of forced parking and escape from danger, so as to reduce accident losses as much as possible.

3、上坡時出現剎車失靈，應適時減入中低擋，保持足夠的動力駛上坡頂停車。如需半坡停車，應保持前進低擋位，拉緊手制動，隨車人員及時用石塊、墊木等物卡住車輪。如有后滑現象，車尾應朝向山坡或一面，并打開大燈和緊急信號燈，引起前后車輛的注意。

3. If the brake fails when going uphill, you should timely reduce to the middle and low gears and keep enough power to drive up the top of the slope and stop. If it is necessary to stop on a half slope, keep the forward low gear, tighten the hand brake, and the vehicle attendant shall timely block the wheels with stones, skids, etc. In case of backward slip, the rear of the vehicle shall face the hillside or the safe side, and turn on the headlights and emergency signal lights to attract the attention of the front and rear vehicles.

4、下坡剎車失靈，不能利用車輛本身的機件控制車速時，駕駛員應果斷地利用天然障礙物，如路旁的巖石、大樹等，給汽車造成阻力。如果一時找不到合適的地形、物體可以利用，緊急情況下可將車身的一側向山邊靠攏，以摩擦來增加阻力，逐漸地降低車速。

4. When the downhill brake fails and the vehicle's own parts cannot be used to control the speed, the driver should decisively use natural obstacles, such as rocks and trees on the roadside, to cause resistance to the vehicle. If suitable terrain and objects can not be found for a while, one side of the car body can be moved closer to the mountain side in an emergency to increase resistance by friction and gradually reduce the speed.

5、攪拌車車輛在下長坡、陡坡時不管有無情況都應該踩一下剎車。既可以檢驗剎車性能，也可以在發現剎車失靈時贏得控制車速的時間，也稱為預見性剎車。

5. The mixer truck should step on the brake when going down long or steep slopes, regardless of whether there is any situation. It can not only test the braking performance, but also win the time to control the speed when the brake fails, which is also called predictive braking.

問題的相關解答就到這里了，您對此有什么不了解的地方或者問題，都可以來我們網站http://jackpetty.net咨詢！

That's all for the answers to your questions. If you have any questions about this, you can come to our website http://jackpetty.net consulting service